Tired of opening and closing a door in your home and noticing (especially hearing) how? rub on the ground, scratching or lifting and having to use force to avoid it? There are several reasons why a door may begin to rub against the floor:

  1. house layout: Over time, homes tend to settle due to changes in the floor or foundation, which can cause the door frames to shift slightly and, as a result, the doors to start rubbing against the floor.
  2. climate changes: Wooden doors can expand and contract with changes in humidity and temperature. In hot or humid climates, wood can swell and cause the door to rub against the floor.
  3. hinge wear: Over time and with frequent use, a door’s hinges can loosen or wear out, causing the door to sag slightly and rub against the floor.
  4. wrong installation: If the door or door frame is installed incorrectly, there may be problems closing the door, including rubbing against the floor.
  5. door wear: In some cases, especially on very old doors, the door itself may bend over time, causing it to rub against the floor.

These are just a few examples and there are other possible causes. This exact solution It will depend on the source of the problem.

Tricks to prevent the door from rubbing against the floor

Tricks to prevent the door from rubbing against the floor INFORMATION


To prevent a door from rubbing against the floor, you have several options, depending on the severity of the problem and the door being used. DIY skills Here are some steps you can take:

  1. adjust the hinges: If the door touches the ground lightly, the hinges may be a little loose. Try tightening the hinge screws with a screwdriver. If the screws are worn, you may want to consider replacing them.
  2. use sandpaper: If the friction isn’t too bad, you can try sanding the bottom of the door to create more space. Remove the door from its hinges, place it on a coffee table or a suitable place to work, and use medium grit sandpaper to abrade the rubbing part. Remember to always sand in the direction of the grain of the wood so as not to damage the door.
  3. cut the door: If the friction is more pronounced, you may need to smooth the bottom of the cap a little. To do this, you must first remove the door from the hinges. Then use a ruler or square to draw a straight line along the piece you want to cut. You can use a handsaw, circular saw or jigsaw to make the cut. After cutting, smooth the edges with sandpaper.
  4. Replace the door or frame: If none of the above work, the door or door frame may be bent. In this case, you may want to consider replacing one or both.

Remember this is always important work safe. Wear safety glasses and gloves when sanding or cutting, and seek help if you need to move the door.