You have a few sites kitchen to collect more dirt and oil this hood Maybe you’re not giving him the attention he deserves. If you don’t normally clean this essential item to remove bad odors because you think it’s hard, here’s one of the best tricks for you. clean the hood in your kitchen. you will see what easy and simpleIt won’t take long for you either. I’m sure Chicote won’t be in for a terrible surprise if she visits your kitchen, but she will be surprised at your efficiency.
How to clean the grease from the extractor grill
It is best to use it to remove grease from the hood degreaserand cleaning the inside of the device is as complex as necessary as it greatly aids its correct operation.
must be degreaser stainless steel, so as not to damage the hood. First you need to remove the filters, then give the interior a good layer of degreaser. then you should let it run for a few minutes then run a cloth or scouring pad over the area. It is likely that the first pass will not be completely clean, so repeat operation.
Of course, use baking soda
It is all-purpose perfection when it comes to house cleaning and in the case of the hood. not an exception. To clean the inside, this trick is perfect for removing even the dirt inside the engine. In this case, first heat the baking soda in several pots with water. Turn on the aspirator when the water starts to boil. Once this is done, let the steam rise and take it inside to clean the appliance, leave it that way for an hour and add water and baking soda as it drains. you will see it start remove the oil from the bells.
After about an hour turn off the heat and protect them with absorbent paper so they don’t get stained with oil and start cleaning the aspirator with a cloth. Also use a brush with a mixture of baking soda and water for some areas and finish the cleaning by running over the brush. sack.
Don’t forget the filters
You can put it in the dishwasher to clean the filters, but if not, put it in a bowl of water and degreaser for a few minutes. Then remove them and run a cloth through the softened oil and use a toothbrush on the most complex areas.
It’s clean outside
To leave the final look, you need to finish it from the outside. This should be done by first turning off the hood. Then you should get one cleaner special for stainless steel and pour over the entire surface, paying attention to the area of ​​the buttons. Let it act for a few seconds and then a cloth is passed in the same direction To which a cleaner is applied, which increases shine and prevents the formation of traces.
Source: Informacion
