Are you tired of opening and closing a door in your home and noticing (especially hearing) how it happens? rubs on the groundscratching or having to lift and use force to avoid it? There are several reasons why a door might start to rub against the floor:

  1. house layout: Over time, houses tend to settle due to changes in the soil or foundation, which can cause door frames to shift slightly, causing doors to rub against the ground.
  2. climate changes: Wooden doors may expand and contract depending on humidity and temperature changes. In humid or hot climates, the wood can swell and cause the door to rub against the floor.
  3. hinge wear: Over time and frequent use, the door’s hinges can become loose or worn, causing the door to sag a little and scratch the floor.
  4. incorrect installation: If the door or door frame is installed incorrectly, problems with closing the door may occur, including rubbing of the floor.
  5. door wear: In some cases, especially on very old doors, the door itself may warp over time, causing it to rub against the floor.

These are just a few examples and there are other possible causes. definitive solution It will depend on the root of the problem.

Tips to prevent the door from rubbing on the ground


Tips to prevent the door from rubbing on the ground INFORMATION

To prevent a door from scraping against the floor, you have several options, depending on the severity of the problem and the use case. DIY skills you have. Here are some steps you can follow:

  1. Adjust the hinges: If the door rubs slightly against the floor, the hinges may be a little loose. Try tightening the hinge screws with a screwdriver. If the screws are worn out, you may want to consider replacing them.
  2. Use sandpaper: If the friction isn’t too bad, you can try sanding the bottom of the door to create more space. Remove the door from the hinges, place it on sawhorses or somewhere convenient to work with, and abrade the rubbing section using medium-grit sandpaper. Remember to always sand in the direction of the grain of the wood to avoid damaging the door.
  3. cut the door: If the rubbing is more noticeable, you may need to trim the bottom of the door a bit. To do this, you must first remove the door from the hinges. Then use a ruler or square to draw a straight line on the piece you want to cut. You can use a hand saw, circular saw or jigsaw to make the cut. After cutting, smooth the edges with sandpaper.
  4. Replace door or frame: If none of the above works, the door or door frame may be warped. In this case, you may want to consider replacing one or both.

Always remember that it is important work safe. Wear safety glasses and gloves when sanding or cutting, and ask for help if you need to move the door.