The washing machine is an essential appliance in our home, but we often neglect one very important part: the door seal. As mold develops over time, this area can affect the quality of your clothing.
Cleaning the rubber in your washing machine and getting rid of mold is not as difficult as you think. Below we provide a complete guide to leaving your washing machine spotless.
The best tricks for the washing machine
To prevent this from happening, it is very important to keep the drum of this device as dry as possible, and to do this, there is nothing better and easier than applying a few homemade tricks that will help us keep mold and moisture away. washing machine. Pay attention to this homemade and natural whitening cleanser:
50 ml white vinegar
250ml water
1 tablespoon baking soda
Steps to clean washing machine rubber
In order to get rid of all the dirt hiding inside the rubber that prevents the washing machine from losing water during washing, you should first check that there are no tissues, coins or even any other items stuck inside. sock.
Then wipe with a damp cloth to remove as much dirt as possible, followed by household bleach. Wet a cloth thoroughly and wipe the inside of the washing machine rubber, or put it in a spray bottle and spray the inside of the rubber until it is thoroughly wet. Leave it for a few minutes and then scrub it with a cloth or sponge to remove as much dirt as possible, then wipe it with a wet cloth to rinse the product and then dry it so that there are no traces of moisture on the surface. device.
If, in addition to dirt, the washing machine rubber is also moldy and nothing comes off, you can use another homemade cleaning trick to eliminate black spots where dirt, bacteria and fungi then cause bad odors. Get into your clothes. The trick is simple and easy to apply: you should make another whitening cleanser that will gradually destroy the mold thanks to the mixture of natural products. Take note:
3 liters of water
60 ml lemon juice
250 ml hydrogen peroxide
The procedure to follow in this case is simple: clean the washing machine rubber as before (wet cloth and sponge to remove as much dirt as possible) and apply a sufficient amount of product to the inside of the rubber. Leave it for a few minutes for the mold to come off and after a while, take it out and dry it thoroughly with a clean cloth.
And in the meantime, take the opportunity to clean the drawer and drum of the washing machine with the same mixture. Put it in the detergent tank and program a long wash cycle at temp. Dry the rubber of the washing machine and drum thoroughly when you are finished. And leave the door open. Get used to leaving it this way after every wash to prevent moisture from accumulating inside and thus avoid possible problems in the future.