build portable solar generator and in addition mobile, It’s not as difficult as it seems. With a few ready-made tools and materials, it’s possible to create a small kit to use anywhere. With the help of the Instructables.com and ecoinventos.com portals, here are some tips for making this builder a reality.
In this case, parts of a children’s bike trailer have been used as the basis of the ‘chassis’, although in reality other similar items could be used.
All the materials used are extremely cheap and The whole set can range from 400 to 700 euros,according to structurals.com.
Necessary materials
- Trailer: While a child bike trailer was used in this case, any similar option you have in your home can be used. In addition to being cut in half, the trailer must also be freed from the plastic body to adapt to its new function. It is then attached to a frame with screws for solid support.
- solar module: A 17 volt, 80 watt module was used in this project.
- Investor: A 400-watt vehicle inverter is used to convert 12 volt DC to 120 AC.
- charge controller: Almost any 12 volt charge controller will help you provide battery protection while charging.
- Battery: A 12 volt battery will be required. You can also use 24, but then you have to make sure the module and inverter are consistent.
-
Mounting material (steel props, supports, nuts, screws, washers, cables…).
Steps to build the generator
1.- Build the trailer
This is really important fix it well so that it is stable and the panel does not come loose. To do this, fix the wood by screwing it to the steel frame. Then use shelf supports or similar to keep the wood upright. It is important that the position is solid, as all electrical installations will go on this plank as seen in the image.
To fix the solar panel, you can use parts that are usually used for this purpose, which you can buy from any specialist supplier. It is also possible to choose traditional materials that you can buy at home or from DIY stores.
Finally, you will need a nylon strap buckle or any string or twine to hold the battery.
2.- Electrical components and wiring.
For electrical installation and wiring, follow the manufacturer’s step-by-step instructions. diagram it was used for mobile solar equipment.
3.- Ready to use.
With that, everything would be ready. Almost an afternoon’s work to pick up equipment that can be very useful for going camping or to the beach, this way you won’t have to give up charging your cell phone or laptop or using a small device. your life easier.
You can find the full instructions at structurals.com.
……….
Contact address of the environment department: [email protected]