a few places kitchen to collect more dirt and oil than the hood and maybe you’re not giving him the attention he deserves. If you’re not cleaning this essential element to remove bad odors because you normally think it’s hard, here’s one of the best tricks you can do. clean the kitchen hood. you will see that easy and simpleIt won’t take long for you either. I’m sure if Chicote visits your kitchen, she won’t be in for a terrible surprise, if not at your efficiency.
How to clean the grease from the extractor grill
Best for removing grease from hood degreaserand cleaning the inside of the device is as complicated as it needs to be, as it helps a lot in its correct operation.
must be degreaser stainless steelso as not to damage the hood. First you need to remove the filters, then apply a good layer of degreaser to the interior. then you should let it act for a few minutes then run a cloth or sponge over the area. It probably won’t be completely clean on the first pass, so you’ll have to repeat operation.
Of course use baking soda
It is an excellent all-purpose when it comes to cleaning the house and when it comes to the hood. not an exception. For cleaning from the inside, this trick is perfect for removing even the dirt inside the engine. In this case, you must first heat the baking soda in several pots with water. When the water starts to boil, the aspirator is turned on. Once this is done you should let the steam rise and go inside the appliance to clean it, leave it that way for an hour and add water and baking soda as it drains. you will see it start remove the oil from the bells.
After about an hour turn off the fire and protect them with absorbent paper so that they are not stained with oil and begin to clean the extractor with a cloth. Also, use a brush with a mixture of bicarbonate and water for some areas and finish the cleaning by running the brush over it. broadcloth.
don’t forget the filters
You can put it in the dishwasher to clean the filters, otherwise you can put them in the dishwasher. put them in a basin of water and degreaser for a few minutes. Then remove the oil that will soften with a cloth and use a toothbrush in the most difficult places.
Clean outside too
You need to finish the exterior to leave the final look. This should be done by first turning off the hood. Then a cleaner special for stainless steel and pour over the entire surface, paying attention to the area where the buttons are. Let it act for a few seconds and then a cloth is passed in the same direction Where the cleanser is applied, which enhances shine and prevents the appearance of scars.